Injector Database › Lucas 01F010A
Lucas 01F010A · Serviced & Flow-Tested

Excelsior-Henderson Super X Motorcycle Fuel Injector Cleaning & Flow Testing

The Lucas 01F010A is a MPFI motorcycle (port injection) fuel injector used in Excelsior-Henderson Super X and its siblings (1999-2000), the short-lived American V-twin. Lucas injector made by Sagem, body stamped 01F010A and 4499-0010, rated about 300 cc/min at 3 bar. Excelsior-Henderson parts are scarce, so cleaning is usually the only option. This set came in rough: three injectors flowing 0-2 ml and two partly blocked. All eight flowed after cleaning, though one still failed the leak test.. We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

ManufacturerLucas
Part number01F010A
TypeMPFI motorcycle (port injection)
ConnectorEV1
Published flow300 cc/min @ 3 bar
Published impedance13.3 Ω

Our measured results

These are the actual before-and-after numbers from our flow bench for the Lucas 01F010A — not published estimates.

Tested in our shop8 injector(s) @ 43.5 psi
Measured coil (avg)12.0 Ω
10s open flow (avg)22.88 → 51.25 ml (+124.0%)
60s pulsed flow (avg)51.62 → 55.5 ml
Leak test after cleaning7/8 PASS

Also known as / cross-references

The Lucas 01F010A is interchangeable with or cross-references to these part numbers:

4499-0010Sagem 01F010A

What vehicles use the Lucas 01F010A?

Excelsior-Henderson Super X and its siblings (1999-2000), the short-lived American V-twin. Lucas injector made by Sagem, body stamped 01F010A and 4499-0010, rated about 300 cc/min at 3 bar. Excelsior-Henderson parts are scarce, so cleaning is usually the only option. This set came in rough: three injectors flowing 0-2 ml and two partly blocked. All eight flowed after cleaning, though one still failed the leak test.

How we service the Lucas 01F010A

Ultrasonic clean, backflush, before-and-after flow and leak test, spray check, tested at 43.5 psi, new seals and filter baskets where available. Full process on our services page.

Frequently asked questions

What did the 01F010A flow at on your bench?
On our bench, 8 01F010A injectors averaged 22.88 ml open flow before cleaning and 51.25 ml after, tested at 43.5 psi.

Send in your 01F010A injectors

Mail-in cleaning and flow testing with a full before/after report. 2-injector minimum, $15 flat round-trip shipping.

Get Started