Yamaha F150 / F175 / F200 4-Stroke Outboard Fuel Injector Cleaning & Flow Testing

The Bosch 6DA-13761-00-00 is a MPFI marine fuel injector used in Yamaha 2.8L outboards: F150, F175, F200 (Bosch-licensed Nikki injector). We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

Manufacturer	Bosch
Part number	6DA-13761-00-00
Type	MPFI marine
Connector	Sumitomo port (EV14 platform)

Get This Injector Serviced

Our measured results

These are the actual before-and-after numbers from our flow bench for the Bosch 6DA-13761-00-00 — not published estimates.

Tested in our shop	4 injector(s) @ 40.0 psi
Measured coil (avg)	12.45 Ω
10s open flow (avg)	74.25 → 75.5 ml (+1.7%)
60s pulsed flow (avg)	70.0 → 69.5 ml
Leak test after cleaning	4/4 PASS

Also known as / cross-references

The Bosch 6DA-13761-00-00 is interchangeable with or cross-references to these part numbers:

Nikki EAT3316DA137610000

What vehicles use the Bosch 6DA-13761-00-00?

Yamaha 2.8L outboards: F150, F175, F200 (Bosch-licensed Nikki injector)

How we service it

Every injector gets ultrasonic cleaning, backflushing, before-and-after flow testing (static and dynamic), leak testing, spray-pattern inspection, and new O-rings and micro-filter baskets where available — plus a detailed Injector Performance Report. Round-trip USPS shipping is $15 flat.

Frequently asked questions

What vehicles use the Bosch 6DA-13761-00-00 injector?

The Bosch 6DA-13761-00-00 is used in Yamaha 2.8L outboards: F150, F175, F200 (Bosch-licensed Nikki injector).

Can you clean and test a 6DA-13761-00-00 injector?

Yes. We ultrasonic-clean, backflush, and flow-test the Bosch 6DA-13761-00-00 on our bench, including before-and-after open and pulsed flow, leak testing, and spray-pattern inspection, with new O-rings where available.

What did the 6DA-13761-00-00 flow at?

On our bench, 4 6DA-13761-00-00 injectors averaged 74.25 ml open flow before cleaning and 75.5 ml after, tested at 40.0 psi.

How much does it cost?

Standard MPFI top-feed injectors are $30 each; side-feed, GDI, TBI and specialty injectors are $35 each. Round-trip shipping is $15 flat, 4-injector minimum.

How do I send them in?

Start an order on our Get Started page, ship your injectors to our Weymouth, MA shop, and we return them cleaned, tested, and documented.

Send in your 6DA-13761-00-00 injectors

Mail-in cleaning and flow testing with a full before/after report. 4-injector minimum, $15 flat round-trip shipping.

Get Started