Yamaha F115 Outboard / Mitsubishi 2.0-3.0L Fuel Injector Cleaning & Flow Testing

The Bosch CDH210 is a MPFI marine + automotive fuel injector used in Yamaha F115 outboard (2000-2015); also Mitsubishi Eclipse/Galant/Mirage, Chevrolet Tracker, Chrysler Sebring, Suzuki Vitara 2.0L/3.0L. Body is Bosch-licensed Nikki.. We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

Manufacturer	Bosch
Part number	CDH210
Type	MPFI marine + automotive
Connector	2-pin (compact)
Published flow	230 cc/min @ 3 bar
	21.9 lb/hr

Get This Injector Serviced

Our measured results

These are the actual before-and-after numbers from our flow bench for the Bosch CDH210 — not published estimates.

Tested in our shop	4 injector(s) @ 40.0 psi
Measured coil (avg)	15.1 Ω
10s open flow (avg)	40.5 → 42.75 ml (+5.6%)
60s pulsed flow (avg)	47.5 → 50.5 ml
Leak test after cleaning	4/4 PASS

Also known as / cross-references

The Bosch CDH210 is interchangeable with or cross-references to these part numbers:

Nikki CDH210INP771MD31979168V8A360000015710-65D00

What vehicles use the Bosch CDH210?

Yamaha F115 outboard (2000-2015); also Mitsubishi Eclipse/Galant/Mirage, Chevrolet Tracker, Chrysler Sebring, Suzuki Vitara 2.0L/3.0L. Body is Bosch-licensed Nikki.

How we service it

Every injector gets ultrasonic cleaning, backflushing, before-and-after flow testing (static and dynamic), leak testing, spray-pattern inspection, and new O-rings and micro-filter baskets where available — plus a detailed Injector Performance Report. Round-trip USPS shipping is $15 flat.

Frequently asked questions

What vehicles use the Bosch CDH210 injector?

The Bosch CDH210 is used in Yamaha F115 outboard (2000-2015); also Mitsubishi Eclipse/Galant/Mirage, Chevrolet Tracker, Chrysler Sebring, Suzuki Vitara 2.0L/3.0L. Body is Bosch-licensed Nikki..

Can you clean and test a CDH210 injector?

Yes. We ultrasonic-clean, backflush, and flow-test the Bosch CDH210 on our bench, including before-and-after open and pulsed flow, leak testing, and spray-pattern inspection, with new O-rings where available.

What did the CDH210 flow at?

On our bench, 4 CDH210 injectors averaged 40.5 ml open flow before cleaning and 42.75 ml after, tested at 40.0 psi.

How much does it cost?

Standard MPFI top-feed injectors are $30 each; side-feed, GDI, TBI and specialty injectors are $35 each. Round-trip shipping is $15 flat, 4-injector minimum.

How do I send them in?

Start an order on our Get Started page, ship your injectors to our Weymouth, MA shop, and we return them cleaned, tested, and documented.

Send in your CDH210 injectors

Mail-in cleaning and flow testing with a full before/after report. 4-injector minimum, $15 flat round-trip shipping.

Get Started