Injector Database › Denso 16611AA860
Denso 16611AA860 · Serviced & Flow-Tested

Subaru BRZ / Toyota 86 FA20 (Port) Fuel Injector Cleaning & Flow Testing

The Denso 16611AA860 is a MPFI (port injector on a dual-injection engine) fuel injector used in Subaru BRZ, Scion FR-S and Toyota 86 2.0L FA20 (about 2013-2020). This engine runs both port and direct injectors; this is the port side. The direct injectors from the same car are 16611JB020.. We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

ManufacturerDenso
Part number16611AA860
TypeMPFI (port injector on a dual-injection engine)

Our measured results

These are the actual before-and-after numbers from our flow bench for the Denso 16611AA860 — not published estimates.

Tested in our shop4 injector(s) @ 43.5 psi
Measured coil (avg)12.0 Ω
10s open flow (avg)34.75 → 36.0 ml (+3.6%)
60s pulsed flow (avg)37.0 → 37.0 ml
Leak test after cleaning4/4 PASS

Also known as / cross-references

The Denso 16611AA860 is interchangeable with or cross-references to these part numbers:

FJ1185

What vehicles use the Denso 16611AA860?

Subaru BRZ, Scion FR-S and Toyota 86 2.0L FA20 (about 2013-2020). This engine runs both port and direct injectors; this is the port side. The direct injectors from the same car are 16611JB020.

How we service the Denso 16611AA860

Ultrasonic clean, backflush, before-and-after flow and leak test, spray check, tested at 43.5 psi, new seals and filter baskets where available. Full process on our services page.

Frequently asked questions

What did the 16611AA860 flow at on your bench?
On our bench, 4 16611AA860 injectors averaged 34.75 ml open flow before cleaning and 36.0 ml after, tested at 43.5 psi.

Send in your 16611AA860 injectors

Mail-in cleaning and flow testing with a full before/after report. 2-injector minimum, $15 flat round-trip shipping.

Get Started