
Subaru BRZ / Toyota 86 FA20 (Direct) Fuel Injector Cleaning & Flow Testing
The Denso 16611JB020 is a GDI (direct injection) fuel injector used in Subaru BRZ, Scion FR-S and Toyota 86 2.0L FA20 (about 2013-2020), Subaru 'Mark 2' direct injector. Low impedance (about 2.2 ohms), tested at high pressure. The port injectors from the same car are 16611AA860. Two of these four came in flowing well under the others: one recovered after cleaning (15 to 31 ml), one did not (11 to 12 ml).. We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.
| Manufacturer | Denso |
| Part number | 16611JB020 |
| Type | GDI (direct injection) |
Our measured results
These are the actual before-and-after numbers from our flow bench for the Denso 16611JB020 — not published estimates.
| Tested in our shop | 4 injector(s) @ 120.0 psi |
| Measured coil (avg) | 2.2 Ω |
| 10s open flow (avg) | 23.5 → 28.75 ml (+22.3%) |
| 60s pulsed flow (avg) | 37.25 → 43.25 ml |
| Leak test after cleaning | 4/4 PASS |
What vehicles use the Denso 16611JB020?
Subaru BRZ, Scion FR-S and Toyota 86 2.0L FA20 (about 2013-2020), Subaru 'Mark 2' direct injector. Low impedance (about 2.2 ohms), tested at high pressure. The port injectors from the same car are 16611AA860. Two of these four came in flowing well under the others: one recovered after cleaning (15 to 31 ml), one did not (11 to 12 ml).
How we service the Denso 16611JB020
Ultrasonic clean, backflush, before-and-after flow and leak test, spray check, tested at 120 psi, new seals and filter baskets where available. Full process on our services page.
Frequently asked questions
What did the 16611JB020 flow at on your bench?
Send in your 16611JB020 injectors
Mail-in cleaning and flow testing with a full before/after report. 2-injector minimum, $15 flat round-trip shipping.
Get Started






