Yamaha HPDI VMAX 200-300 HP 2-Stroke Fuel Injector Cleaning & Flow Testing

The Yamaha 60V-13761-00-00 is a DFI marine (2-stroke high-pressure direct injection) fuel injector used in Yamaha HPDI VMAX 2-stroke direct injection outboards: 200, 225, 250, 300 HP (2003-2009). We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

Manufacturer	Yamaha
Part number	60V-13761-00-00
Type	DFI marine (2-stroke high-pressure direct injection)

Get This Injector Serviced

Our measured results

These are the actual before-and-after numbers from our flow bench for the Yamaha 60V-13761-00-00 — not published estimates.

Tested in our shop	6 injector(s) @ 120.0 psi
Measured coil (avg)	1.3 Ω
10s open flow (avg)	70.5 → 71.67 ml (+1.7%)
60s pulsed flow (avg)	98.5 → 96.0 ml
Leak test after cleaning	6/6 PASS

Also known as / cross-references

The Yamaha 60V-13761-00-00 is interchangeable with or cross-references to these part numbers:

60V137610000

What vehicles use the Yamaha 60V-13761-00-00?

Yamaha HPDI VMAX 2-stroke direct injection outboards: 200, 225, 250, 300 HP (2003-2009)

How we service it

Every injector gets ultrasonic cleaning, backflushing, before-and-after flow testing (static and dynamic), leak testing, spray-pattern inspection, and new O-rings and micro-filter baskets where available — plus a detailed Injector Performance Report. Round-trip USPS shipping is $15 flat.

Frequently asked questions

What vehicles use the Yamaha 60V-13761-00-00 injector?

The Yamaha 60V-13761-00-00 is used in Yamaha HPDI VMAX 2-stroke direct injection outboards: 200, 225, 250, 300 HP (2003-2009).

Can you clean and test a 60V-13761-00-00 injector?

Yes. We ultrasonic-clean, backflush, and flow-test the Yamaha 60V-13761-00-00 on our bench, including before-and-after open and pulsed flow, leak testing, and spray-pattern inspection, with new O-rings where available.

What did the 60V-13761-00-00 flow at?

On our bench, 6 60V-13761-00-00 injectors averaged 70.5 ml open flow before cleaning and 71.67 ml after, tested at 120.0 psi.

How much does it cost?

Standard MPFI top-feed injectors are $30 each; side-feed, GDI, TBI and specialty injectors are $35 each. Round-trip shipping is $15 flat, 4-injector minimum.

How do I send them in?

Start an order on our Get Started page, ship your injectors to our Weymouth, MA shop, and we return them cleaned, tested, and documented.

Send in your 60V-13761-00-00 injectors

Mail-in cleaning and flow testing with a full before/after report. 4-injector minimum, $15 flat round-trip shipping.

Get Started