Yamaha F75 / F90 / F100 4-Stroke Outboard Fuel Injector Cleaning & Flow Testing

The Yamaha 6D8-13761-00-00 is a MPFI marine fuel injector used in Yamaha F75, F90, F100 4-stroke outboards (2005-2017); Mercury/Mariner 75, 90, 100 HP EFI 4-stroke (Yamaha-built powerheads). Red-body variant, same body as the blue version.. We ultrasonic-clean and flow-test injectors like this one in our shop, then send back before-and-after data so you know exactly what you're getting.

Manufacturer	Yamaha
Part number	6D8-13761-00-00
Type	MPFI marine

Get This Injector Serviced

Our measured results

These are the actual before-and-after numbers from our flow bench for the Yamaha 6D8-13761-00-00 — not published estimates.

Tested in our shop	4 injector(s) @ 40.0 psi
Measured coil (avg)	12.7 Ω
10s open flow (avg)	14.75 → 32.0 ml (+116.9%)
60s pulsed flow (avg)	25.75 → 34.25 ml
Leak test after cleaning	4/4 PASS

Also known as / cross-references

The Yamaha 6D8-13761-00-00 is interchangeable with or cross-references to these part numbers:

880887T02 (Mercury)6D8-13761-006D8137610000

What vehicles use the Yamaha 6D8-13761-00-00?

Yamaha F75, F90, F100 4-stroke outboards (2005-2017); Mercury/Mariner 75, 90, 100 HP EFI 4-stroke (Yamaha-built powerheads). Red-body variant, same body as the blue version.

How we service it

Every injector gets ultrasonic cleaning, backflushing, before-and-after flow testing (static and dynamic), leak testing, spray-pattern inspection, and new O-rings and micro-filter baskets where available — plus a detailed Injector Performance Report. Round-trip USPS shipping is $15 flat.

Frequently asked questions

What vehicles use the Yamaha 6D8-13761-00-00 injector?

The Yamaha 6D8-13761-00-00 is used in Yamaha F75, F90, F100 4-stroke outboards (2005-2017); Mercury/Mariner 75, 90, 100 HP EFI 4-stroke (Yamaha-built powerheads). Red-body variant, same body as the blue version..

Can you clean and test a 6D8-13761-00-00 injector?

Yes. We ultrasonic-clean, backflush, and flow-test the Yamaha 6D8-13761-00-00 on our bench, including before-and-after open and pulsed flow, leak testing, and spray-pattern inspection, with new O-rings where available.

What did the 6D8-13761-00-00 flow at?

On our bench, 4 6D8-13761-00-00 injectors averaged 14.75 ml open flow before cleaning and 32.0 ml after, tested at 40.0 psi.

How much does it cost?

Standard MPFI top-feed injectors are $30 each; side-feed, GDI, TBI and specialty injectors are $35 each. Round-trip shipping is $15 flat, 4-injector minimum.

How do I send them in?

Start an order on our Get Started page, ship your injectors to our Weymouth, MA shop, and we return them cleaned, tested, and documented.

Send in your 6D8-13761-00-00 injectors

Mail-in cleaning and flow testing with a full before/after report. 4-injector minimum, $15 flat round-trip shipping.

Get Started